Product Selection Guide Enquiry Form

Please fill the form and click submit to visit product selection guide page.


Trolley Mounted HT Cable Fault Locating System HICOMP

Surge Tester / Thumper

Cable Route Tracer

Cable Fault Pre Locator

Surge Receiver / Pin point Locator

High Pot tester

Sheath Fault Tester

Cable Identification System

Compact System

Trolley Mounted System

Van / Trailer Mounted System

Low Cost Van System

Cable Burn Down Equipment

Soft Discharge Rod

IP67 / IP54 Products



The cable fault locating system HICOMP is used to pre-location of fault distance with the help of pre-locator and pin-point cable fault using surge tester in acoustic method with the help of surge wave receiver in low voltage power cable network.
  • Pin-point location of cable faults in High voltage cables by acoustic method.
  • Output voltage selectable in two ranges 0-4kV, 8KV & 16 kV continuously variable.
  • High energy of 500 Joules ( Optional 1000Joules).
  • Full energy delivering capacity at each select range.
  • Single Impulse and 1.5, 3 and 6 seconds intervals or as per sequence customer request.
  • Pre-location of cable fault distance with TDR and ICM method.
  • Maximum range of 100 km for pre-location of cable faults.
  • Power Supply 230V AC + 10%, 50Hz single phase.
Trolley System Consists of
Low Voltage Surge Tester SWT 16
Surge Wave Receiver SLE 90
Cable Fault Pre-locator TFL 8
Trolley with cable drum 20mtr. Each.